<![CDATA[SoliForum - 3D Printing Community — Davinci LED pinout?]]> https://www.soliforum.com/topic/14142/davinci-led-pinout/ Tue, 08 Nov 2022 17:53:37 +0000 PunBB <![CDATA[Re: Davinci LED pinout?]]> https://www.soliforum.com/post/155481/#p155481 Not really, they say that you should pay special attention to the power supply and current converter. If you take the wifi light bulb, you need to provide the connection source with the right voltage. If it is a section of the circuit, the values are best measured with an ammeter and voltmeter. If a direct connection is made to the current source (this may be a rectifier, battery or battery), it will be sufficient to know their ratings as indicated in the marking or accompanying documentation. The 5v line designation is just confusing. Re-measure everything and try a different power supply

]]> Tue, 08 Nov 2022 17:53:37 +0000 https://www.soliforum.com/post/155481/#p155481 <![CDATA[Re: Davinci LED pinout?]]> https://www.soliforum.com/post/127082/#p127082 sshawn has it right. The 12V is used to power the LED strip, while the 5v line is for turning it off/on via a controller pin.

I have a DaVinci Jr LED strip -- I'm sure it's similar if not identical -- that I hooked up to a pin on my RAMPS 1.4 board, and I can turn it on/off via the 5v pin (even control its brightness by setting the pin half on).

]]> Fri, 23 Sep 2016 12:45:04 +0000 https://www.soliforum.com/post/127082/#p127082 <![CDATA[Re: Davinci LED pinout?]]> https://www.soliforum.com/post/126986/#p126986 Did you ever figure it out? I have a DaVinci 1.1, here is how you do it:

Carrot marked on LED board, put grnd in middle:

                               12v    Grnd      5V
LED Mobo Marking    |          |          |
                                                     ^

http://soliforum.com/i/?6HF8SDg.jpg

]]> Sat, 17 Sep 2016 19:24:23 +0000 https://www.soliforum.com/post/126986/#p126986 <![CDATA[Re: Davinci LED pinout?]]> https://www.soliforum.com/post/118175/#p118175 If I remember right its 5v

]]> Sun, 28 Feb 2016 01:27:08 +0000 https://www.soliforum.com/post/118175/#p118175 <![CDATA[Davinci LED pinout?]]> https://www.soliforum.com/post/118173/#p118173 I'm replacing the electronics on my Davinci with a RAMPS 1.4 board.  Last item on my list is this:  The LED light strip in the enclosure oddly has a 3 wire hookup.  Any idea what this is?  (Most LEDs are either 2 wire (single color) or 4 wire (RGB leds) )

Also, anyone know that the voltage for the LED strip is?  12V?  5V? 3.3V?

]]> Sun, 28 Feb 2016 00:37:53 +0000 https://www.soliforum.com/post/118173/#p118173