<![CDATA[SoliForum - 3D Printing Community — Having Issues with Repetier Software and the Davinci 1.0A]]> https://www.soliforum.com/topic/14085/having-issues-with-repetier-software-and-the-davinci-10a/ Wed, 24 Feb 2016 23:39:07 +0000 PunBB <![CDATA[Re: Having Issues with Repetier Software and the Davinci 1.0A]]> https://www.soliforum.com/post/117836/#p117836 ABS is normally in the 235 range. Your image however is what happens when the base of your print comes free and the printer then just prints in the air. So your bed adhesion and maybe first layer quality is bad.

]]> Wed, 24 Feb 2016 23:39:07 +0000 https://www.soliforum.com/post/117836/#p117836 <![CDATA[Re: Having Issues with Repetier Software and the Davinci 1.0A]]> https://www.soliforum.com/post/117824/#p117824 Is it possible that the Extruder Temp I am using is incorrect?  I am using 200c with Standard Davinci ABS Filament 1.75...  Bed Temp of 110.

-Sal-

]]> Wed, 24 Feb 2016 22:16:03 +0000 https://www.soliforum.com/post/117824/#p117824 <![CDATA[Re: Having Issues with Repetier Software and the Davinci 1.0A]]> https://www.soliforum.com/post/117790/#p117790 Looks like poor bed adhesion. Adjust your nozzle height properly and use glue stick.

]]> Wed, 24 Feb 2016 19:34:04 +0000 https://www.soliforum.com/post/117790/#p117790 <![CDATA[Having Issues with Repetier Software and the Davinci 1.0A]]> https://www.soliforum.com/post/117739/#p117739 I am having some bizarre problems with my DaVinci Printer after installing the Repetier Firmware.  I am sure that it is some type of configuration problem...  Just not sure where to begin in correcting the issue.  Please look at image attached.

-Sal-

]]> Wed, 24 Feb 2016 16:08:00 +0000 https://www.soliforum.com/post/117739/#p117739