SoliForum - 3D Printing Community — Can't connect to Press after E3Dv6 upgrade

Re: Can't connect to Press after E3Dv6 upgrade

null@example.com (ScRamjet) — Fri, 22 Apr 2016 22:03:20 +0000

I can't give much help but I can say mine works fine on Windows 10.
Have you tried uninstalling, reboot the Comp then re-install Solidoodle and drivers?

Re: Can't connect to Press after E3Dv6 upgrade

null@example.com (cedric.leclerc05) — Tue, 01 Mar 2016 02:53:42 +0000

Yep, it is not on

Re: Can't connect to Press after E3Dv6 upgrade

null@example.com (gamera3) — Wed, 24 Feb 2016 19:50:27 +0000

cedric.leclerc05 wrote:

Hey guys!
Just did the E3Dv6 upgrade on my press since I broke the stock hotend while cleaning it... Everything went smooth during the upgrade, I have done it with an USBTinyISP programmer and AVRDudess to flash the firmware provided by MacGyverX, the boot jumper was in place during the upload and no error appeared during the writing.
The printer turns on normally but Windows seems to fail at detecting it, nothing shows up in the driver manager. I'm running Windows 10, which I think could be the problem, any clues?
Thanks!

Have you checked if you left the jumper in the board??

Can't connect to Press after E3Dv6 upgrade

null@example.com (cedric.leclerc05) — Mon, 22 Feb 2016 04:06:38 +0000

Hey guys!

Just did the E3Dv6 upgrade on my press since I broke the stock hotend while cleaning it... Everything went smooth during the upgrade, I have done it with an USBTinyISP programmer and AVRDudess to flash the firmware provided by MacGyverX, the boot jumper was in place during the upload and no error appeared during the writing.

The printer turns on normally but Windows seems to fail at detecting it, nothing shows up in the driver manager. I'm running Windows 10, which I think could be the problem, any clues?

Thanks!