<![CDATA[SoliForum - 3D Printing Community — question about filawinder]]> https://www.soliforum.com/topic/13795/question-about-filawinder/ Sat, 20 Feb 2016 01:24:03 +0000 PunBB <![CDATA[Re: question about filawinder]]> https://www.soliforum.com/post/117015/#p117015 thankyou for your time the pot dose not move winder in Manuel mode and i cannot see any change with the center button
i will double check my wiring i am not to good on computers please be patient

rgreen

]]> Sat, 20 Feb 2016 01:24:03 +0000 https://www.soliforum.com/post/117015/#p117015 <![CDATA[Re: question about filawinder]]> https://www.soliforum.com/post/117014/#p117014 os3dp wrote:

rgreen:
Try calibrating the sensor. In the manual:

While in Manual mode the knob controls the speed of the spool, and the middle button activates the sensor calibration. Pick up a short length of filament and press and release the middle button. The winder will enter calibration mode for the next five seconds during which you should wave the filament up and down between the laser and the photocells. It will record the lightest and darkest values received during that time, which it will use to recognize the filament’s shadow.

-os3dp

]]> Sat, 20 Feb 2016 01:15:27 +0000 https://www.soliforum.com/post/117014/#p117014 <![CDATA[Re: question about filawinder]]> https://www.soliforum.com/post/117010/#p117010 rgreen:
Try calibrating the sensor. In the manual:

While in Manual mode the knob controls the speed of the spool, and the middle button activates the sensor calibration. Pick up a short length of filament and press and release the middle button. The winder will enter calibration mode for the next five seconds during which you should wave the filament up and down between the laser and the photocells. It will record the lightest and darkest values received during that time, which it will use to recognize the filament’s shadow.

-os3dp

]]> Sat, 20 Feb 2016 00:03:50 +0000 https://www.soliforum.com/post/117010/#p117010 <![CDATA[question about filawinder]]> https://www.soliforum.com/post/117002/#p117002 Hi to every one i just got my filawinder assembled and i cannot get laser to except 1.75 filament the winder works
well if you use your finger to trip  the photo resistors speed is easily controlled.
i have checked all solder joints and the servo is working correct i do not know were to go from here
and thankyou in advance

Randy

]]> Fri, 19 Feb 2016 22:26:12 +0000 https://www.soliforum.com/post/117002/#p117002