SoliForum - 3D Printing Community — Wired E3D v6 jamming issue after printing PMMA filament

Re: Wired E3D v6 jamming issue after printing PMMA filament

null@example.com (tlc531) — Sun, 14 Feb 2016 04:12:13 +0000

If using an E3DV6 hotend on a Da Vinci printer, do as I do, on some of my other printers. Heat up the hotend a few degrees above recommended filament temp. Once temp reached, push down by hand on the filament and then immediately pull out. Works everytime and leaves a clean nozzle.

Re: Wired E3D v6 jamming issue after printing PMMA filament

null@example.com (DopeSkrit) — Fri, 12 Feb 2016 12:25:20 +0000

carl_m1968 wrote:

You will have this issue any time you run high temps then go back to lowers. You have to load the lower tempt at the higher temp and purge a few 100mm through to flush out the remaining high temp stuff. other wise it will not melt at the lower tmep and cause a clog.

But usually if I am printing ABS and I want to go back to PLA I extrude 300mm-400mm of PLA at 230 and it works fine. But I wasted 5m of PLA trying to flush out the PMMA.

Re: Wired E3D v6 jamming issue after printing PMMA filament

null@example.com (carl_m1968) — Thu, 11 Feb 2016 23:50:50 +0000

You will have this issue any time you run high temps then go back to lowers. You have to load the lower tempt at the higher temp and purge a few 100mm through to flush out the remaining high temp stuff. other wise it will not melt at the lower tmep and cause a clog.

Wired E3D v6 jamming issue after printing PMMA filament

null@example.com (DopeSkrit) — Thu, 11 Feb 2016 21:24:00 +0000

So I recently picked up a roll of PMMA Filament (https://en.wikipedia.org/wiki/Poly%28me … crylate%29) after printing some test prints I wanted to switch back to my usual PLA and it jammed sometimes but sometimes it worked. After heating up my hotend to 250 and extruding 5m of PLA plastic it worked again (I unloaded the PLA 4 times at 90°C). Have somebody exprienced similar issues when printing high temp plastics with the v6?