<![CDATA[SoliForum - 3D Printing Community — Thermistor Resistance reading]]> https://www.soliforum.com/topic/13572/thermistor-resistance-reading/ Sun, 31 Jan 2016 04:02:05 +0000 PunBB <![CDATA[Re: Thermistor Resistance reading]]> https://www.soliforum.com/post/115389/#p115389 elmoret wrote:

Bad connection somewhere in the thermistor wiring.

With the thermistor at room temperature, you should be using something more like 200k as a setting on your meter.


D'oh, stupid me. I think I missed that little "k" In the troubleshoot I was reading. Any recommendations on how to find where the bad wire is? Or should I just buy a new thermistor?

]]> Sun, 31 Jan 2016 04:02:05 +0000 https://www.soliforum.com/post/115389/#p115389 <![CDATA[Re: Thermistor Resistance reading]]> https://www.soliforum.com/post/115387/#p115387 Bad connection somewhere in the thermistor wiring.

With the thermistor at room temperature, you should be using something more like 200k as a setting on your meter.

]]> Sun, 31 Jan 2016 03:46:14 +0000 https://www.soliforum.com/post/115387/#p115387 <![CDATA[Thermistor Resistance reading]]> https://www.soliforum.com/post/115385/#p115385 I've been getting the dreaded "Printer stopped due to errors. Fix the error and use M999..." So I figure it must be a thermistor problem. I unplugged the thermistor and tried to get a multi-meter reading at 200ohms but I couldn't' get a reading no matter what pins i touched. Even though that's the case it seems to read temperature fine when I start to heat up my extruder end. What's the deal?

The printer is usually running great for about an hour and then it goes into that error.

]]> Sun, 31 Jan 2016 03:39:04 +0000 https://www.soliforum.com/post/115385/#p115385