SoliForum - 3D Printing Community — Slicer printing out of the bed?

Re: Slicer printing out of the bed?

null@example.com (manueslapera) — Mon, 18 Feb 2013 03:16:18 +0000

And yeah, I'm using Windows 7

Re: Slicer printing out of the bed?

null@example.com (manueslapera) — Mon, 18 Feb 2013 03:15:45 +0000

Hi!

I installed that one, and before i installed the Solidoodle All in one package available at the SDd site ( i cant post links)

I was researching with my machine, and I noticed that sometimes the Y axis stops moving in one direction - it gives the echo endstop even when its not at the end.

Then I found a google groups thread talking that this might happen because of the belts not being aligned

However, this thread is about the SD2, and I am not sure if that might be the cause of the errors i'm experiencing

Any help with this would be greatly appreciated, i was so excited about this printer and i am not able to print with it.

Re: Slicer printing out of the bed?

null@example.com (ronsii) — Sun, 17 Feb 2013 05:42:59 +0000

Did you d/l the software from the link at solidoodle.com ---> http://dl.dropbox.com/u/90605134/setupR … e_0_82.exe

just guessing you are using the windows system???

Also check out here --> http://solidoodletips.wordpress.com/201 … tier-host/

Slicer printing out of the bed?

null@example.com (manueslapera) — Sun, 17 Feb 2013 01:30:13 +0000

Hi!

I just received the brand new SD3, the issue i have is that, when I use the Repetier package to produce the gcode and load it to print, even whne i center the piece, it tries to print it outside of the bed,

Is this an issue of the SD not knowing were the origin is? if so, how could i fix it?