SoliForum - 3D Printing Community — Filastruder from Italy

Re: Filastruder from Italy

null@example.com (elmoret) — Tue, 26 Jan 2016 20:31:48 +0000

PTFE is used because it is lower friction than aluminum, so the filament slides over it more easily.

null@example.com (Labieno) — Tue, 26 Jan 2016 20:25:47 +0000

Thank you Rev, may be that an aluminium one could be better?

null@example.com (elmoret) — Tue, 26 Jan 2016 18:34:59 +0000

^ this guy is correct!

null@example.com (Revolve3D) — Tue, 26 Jan 2016 18:16:51 +0000

I don't have a 2.0 model but I believe the PTFE tube would go in the T shaped slot in front of the fan where the filament touches the wood case.

null@example.com (Labieno) — Tue, 26 Jan 2016 17:45:45 +0000

elmoret wrote:

Looking good!
If you have problems with kinking, you might want to slide that fan mount back a bit and put the PTFE tube in the slot.

Hi Tim,

I'm sorry I haven't understood which is the slot to put the PTFE tube.
Can you send a picture.

Regards

null@example.com (Superdave) — Mon, 25 Jan 2016 02:20:15 +0000

Cool bottle and nice assembly.

null@example.com (elmoret) — Sun, 24 Jan 2016 19:13:22 +0000

Looking good!

If you have problems with kinking, you might want to slide that fan mount back a bit and put the PTFE tube in the slot.

null@example.com (Labieno) — Sun, 24 Jan 2016 11:50:11 +0000

Hi everybody,

I send a picture of a working Italian Filastruder

Best regards from Italy