<![CDATA[SoliForum - 3D Printing Community — Need latest Repetier settings for Printers]]> https://www.soliforum.com/topic/1336/need-latest-repetier-settings-for-printers/ Fri, 15 Feb 2013 23:08:49 +0000 PunBB <![CDATA[Re: Need latest Repetier settings for Printers]]> https://www.soliforum.com/post/12900/#p12900 Ah,

I setup RH on my surface pro 2 days and used this:
http://dl.dropbox.com/u/90605134/setupR … e_0_82.exe

]]> Fri, 15 Feb 2013 23:08:49 +0000 https://www.soliforum.com/post/12900/#p12900 <![CDATA[Re: Need latest Repetier settings for Printers]]> https://www.soliforum.com/post/12898/#p12898 Thanks! 

Sorry.  I meant the definitions of each Printer in Repetier Host, not the Printer definitions in Slic3r.  I can find the Slic3r files just fine.  Things like bed dimensions, dump areas, etc.

]]> Fri, 15 Feb 2013 22:52:28 +0000 https://www.soliforum.com/post/12898/#p12898 <![CDATA[Re: Need latest Repetier settings for Printers]]> https://www.soliforum.com/post/12891/#p12891 They can be found here: http://www.solidoodle.com/2012/11/1495/

]]> Fri, 15 Feb 2013 20:20:27 +0000 https://www.soliforum.com/post/12891/#p12891 <![CDATA[Re: Need latest Repetier settings for Printers]]> https://www.soliforum.com/post/12890/#p12890 You can manually setup your profiles at this point I bet 80).  Just look at what each does and fine tune it to your part.  Here is what I focus on.

The most important things to take notice of are nozzle size, extrusion with, retraction settings, layer height, perimeters (I stay around .20 for a balance of quality and speed) -- these all have major impacts on the quality of print.

Infill - I always use concentric on top/bot and honeycomb for the inside.

Perimeters- raise this number if you see holes (assuming you properly fixed your file) -- the lower the Layer Height the more you will need.  You can also sometime use more perimeters instead of turning on support.

]]> Fri, 15 Feb 2013 20:18:30 +0000 https://www.soliforum.com/post/12890/#p12890 <![CDATA[Need latest Repetier settings for Printers]]> https://www.soliforum.com/post/12873/#p12873 I installed Win8 on top of my old Win7 system, and can no longer find my settings for my Repetier Host Printers.  I looked everywhere for a file that might contain the settings, but was unsuccessful.  Would someone please share those settings (probably best with screen shots)? 

I also do not have any current Slic3r settings (although I did manage to find and preserve my older Slic3r settings).

Thanks!

]]> Fri, 15 Feb 2013 18:19:33 +0000 https://www.soliforum.com/post/12873/#p12873