https://www.soliforum.com/topic/1325/first-print-curled/ Wed, 13 Feb 2013 12:41:33 +0000 PunBB https://www.soliforum.com/post/12683/#p12683 95deg, hairspray, and enclosed build environment.   Then try again.

]]> Wed, 13 Feb 2013 12:41:33 +0000 https://www.soliforum.com/post/12683/#p12683 https://www.soliforum.com/post/12679/#p12679 Since you are using glass on top of the heated bed you need to check the glass temp.  Those readings are from the aluminum plate so the temp of the glass could be anywhere from 5-10d off.  I would try running bed at 95d and see how that prints.  Some people use hairspray to make it stick to the glass as the plastic doesnt stick well to just glass.

]]> Wed, 13 Feb 2013 11:00:20 +0000 https://www.soliforum.com/post/12679/#p12679 https://www.soliforum.com/post/12678/#p12678 I ran a test print and it curled.
the bed is warped and I usec a piece of 3/32 glass but it flexes to bad.
Using Octive fluorescent red filiment
bed temp 85° C
extruder 200° C
printer Enclosed
I have to go with 1/8" glass but do i need to up my bed temp

]]> Wed, 13 Feb 2013 10:35:59 +0000 https://www.soliforum.com/post/12678/#p12678