https://www.soliforum.com/topic/13155/afinia-h800-nozzel-problems/ Wed, 23 Dec 2015 04:45:20 +0000 PunBB https://www.soliforum.com/post/112387/#p112387 Try increasing temps in increments if 5.

]]> Wed, 23 Dec 2015 04:45:20 +0000 https://www.soliforum.com/post/112387/#p112387 https://www.soliforum.com/post/112384/#p112384 I have been using the Afinia H800 for a few months now and just cant seem to get it to work with other filaments. I have had some success with the Hatchbox brand. I just installed the Octave temp switch and have done some test prints. Only problem is i get about 75% of the way through the prints and then the nozzle jams or something. I am using the recommended temps and the part that prints come out very nice. The raft comes off easy. it looks like the nozzle jams up. I withdraw the filament and try again with the same result. Any advice on this would be very appreciated. I want to be able to use other filaments without this problem.

]]> Wed, 23 Dec 2015 04:04:18 +0000 https://www.soliforum.com/post/112384/#p112384