SoliForum - 3D Printing Community — Help , displacement problem with X axis

Re: Help , displacement problem with X axis

null@example.com (Jukalo) — Thu, 17 Dec 2015 23:04:43 +0000

Hi wides,

Sorry for the angle, you have absolutely right, but first you detect my problem, but not from the model and I have analyzed different models. What happens is that when it starts to print skirt, there is a shift in the X axis and starts at a point where it isn't should start, as if losing the originating and as you can see after print skirt the rest of the model is mounted on initial layers and it will displace along the impression. You understand me?

I will try to post another video with the problem but if you have any idea , please send me what is the solution.

Re: Help , displacement problem with X axis

null@example.com (widespreaddeadhead) — Thu, 17 Dec 2015 14:33:04 +0000

The video is at a kinda weird angle but toward the end I think I saw the problem. Correct me if I'm wrong, but you're printing a skirt and then when it starts to print the model, it overlaps onto the skirt?

If so, check the model you're trying to print. Specifically check to make sure it's lying completely flat against the bed before you print. If you're using RH or OctoPi check the preview G-code starting at Layer 1, if everything looks ok, check the next layer to see when in the G-code it starts to overlap the skirt. This will let you know if it's a problem with the model.

The skirt is in yellow and the model is in red.

Help , displacement problem with X axis

null@example.com (Jukalo) — Thu, 17 Dec 2015 13:50:45 +0000

Hi everybody,

I need help to solve this problem. I have a SD3 for more than 2 years and since yesterday is presenting a problem when it starts to extrude. An offset of the X axis as seen in the video it looks. I don't know if damage to the engine or electronic board .. anyone know it can be and how to solve it?

Best regards,