<![CDATA[SoliForum - 3D Printing Community — Extruder]]> https://www.soliforum.com/topic/13102/extruder/ Wed, 16 Dec 2015 19:40:43 +0000 PunBB <![CDATA[Re: Extruder]]> https://www.soliforum.com/post/111805/#p111805 Sometimes I can't even get the filament to come out after the print started.  Like I'll get it to extrude but then when I start the print nothing comes out...  Help?

]]> Wed, 16 Dec 2015 19:40:43 +0000 https://www.soliforum.com/post/111805/#p111805 <![CDATA[Re: Extruder]]> https://www.soliforum.com/post/111804/#p111804 dedafmonteur wrote:

It could be cheap filament. What do you use?

I use filament I bought from the solidoodle store, not the stuff that came with the printer.  It is blue

]]> Wed, 16 Dec 2015 19:38:12 +0000 https://www.soliforum.com/post/111804/#p111804 <![CDATA[Re: Extruder]]> https://www.soliforum.com/post/111794/#p111794 Room temperature ? Make sure its not that high. Try printing with window open (since its winter, maybe you can prinnt with very very low room temp). If that works, post here.

]]> Wed, 16 Dec 2015 18:32:16 +0000 https://www.soliforum.com/post/111794/#p111794 <![CDATA[Re: Extruder]]> https://www.soliforum.com/post/111786/#p111786 It could be cheap filament. What do you use?

]]> Wed, 16 Dec 2015 17:38:58 +0000 https://www.soliforum.com/post/111786/#p111786 <![CDATA[Extruder]]> https://www.soliforum.com/post/111702/#p111702 About half way through every print the extruder goes thunk-thunk-thunk.  I know its getting clogged.  Ive tried raising the temperature, keeping the lid open.  What else could i possibly do? Thanks in advance.

]]> Tue, 15 Dec 2015 22:14:37 +0000 https://www.soliforum.com/post/111702/#p111702