https://www.soliforum.com/topic/13032/x-axis-homing-issue/ Sat, 05 Dec 2015 17:13:59 +0000 PunBB https://www.soliforum.com/post/111018/#p111018 Yep just happy you got it fixed.

]]> Sat, 05 Dec 2015 17:13:59 +0000 https://www.soliforum.com/post/111018/#p111018 https://www.soliforum.com/post/111017/#p111017 Ok after taking the switch out and testing everything I couldn't find anything wrong, I put back together and everything's working fine somehow. Must have been a loose connection somewhere:) Thanks for your help.

]]> Sat, 05 Dec 2015 16:57:43 +0000 https://www.soliforum.com/post/111017/#p111017 https://www.soliforum.com/post/111002/#p111002 The X stop switch seems to be working just fine. But the problem still persists.

]]> Sat, 05 Dec 2015 02:35:01 +0000 https://www.soliforum.com/post/111002/#p111002 https://www.soliforum.com/post/110997/#p110997 Yep use a continuity tester or a DMM.  Unplug it from the board and test for continuity at the plug with the switch triggered there should be no continuity and with the switch not depressed there should be continuity.

]]> Sat, 05 Dec 2015 01:34:18 +0000 https://www.soliforum.com/post/110997/#p110997 https://www.soliforum.com/post/110992/#p110992 Hmm the wires all look good. Is there any way to see if its making connection to the computer for sure?

]]> Fri, 04 Dec 2015 23:44:55 +0000 https://www.soliforum.com/post/110992/#p110992 https://www.soliforum.com/post/110989/#p110989 Sounds like the X axis endstop has a loose connection or broken wire.

]]> Fri, 04 Dec 2015 23:21:18 +0000 https://www.soliforum.com/post/110989/#p110989 https://www.soliforum.com/post/110987/#p110987 Hi, after letting my Press sitting in the corner for a while the x axis isn't homing. The extruder doesn't move to the right(toward the x stop) at all, instead when I try to home the x axis it moves about 10 mm to the left then stops! Then it sets that as home. I was able to move it to the right with the manual control. So I tried turning of the printer and moving the extruder manually to the end stop, then I started it up and pressed home all, after moving to the left and popping down the probe it set that place as home for the x axis, keeping it from moving back to the center to home the z. I'm using Repetier Host and I've also tried using Matter Control. I've re-flashed the firmware but no success. Any help would be very appreciated.

]]> Fri, 04 Dec 2015 23:09:00 +0000 https://www.soliforum.com/post/110987/#p110987