<![CDATA[SoliForum - 3D Printing Community — Kit built, not scanner..]]> https://www.soliforum.com/topic/12902/kit-built-not-scanner/ Mon, 23 Nov 2015 01:53:57 +0000 PunBB <![CDATA[Re: Kit built, not scanner..]]> https://www.soliforum.com/post/110057/#p110057 You'll probably get a better response over in the ATLAS section.

]]> Mon, 23 Nov 2015 01:53:57 +0000 https://www.soliforum.com/post/110057/#p110057 <![CDATA[Kit built, not scanner..]]> https://www.soliforum.com/post/110046/#p110046 Received the precut kit, and assembled with my kickstarter order. All was going well till we attempted to use.

Could only get one laser to fire, opened whole thing back up to check wiring. Everything looks fine. We test the right laser, and the motor / table turns, but no right laser.

We installed and updated the software the software on the raspberry pi..

Rechecked all wiring.. (A wiring diagram would be nice) following, trying to understand the video (since we are using a different kit)) is difficult..

Does anyone have the new Setup/Settings? Perhaps we have the wrong Pin, or x/y settings..

Please help
~david

]]> Sun, 22 Nov 2015 20:45:18 +0000 https://www.soliforum.com/post/110046/#p110046