<![CDATA[SoliForum - 3D Printing Community — Stepper Disabled Error]]> https://www.soliforum.com/topic/12862/stepper-disabled-error/ Fri, 20 Nov 2015 22:54:11 +0000 PunBB <![CDATA[Re: Stepper Disabled Error]]> https://www.soliforum.com/post/109958/#p109958 It could be caused by the motor or the driver over heating because the vref is set too high. You might want to see if you can lower it. Ideally it should be set as low as possible without skipping.

]]> Fri, 20 Nov 2015 22:54:11 +0000 https://www.soliforum.com/post/109958/#p109958 <![CDATA[Re: Stepper Disabled Error]]> https://www.soliforum.com/post/109957/#p109957 Oh, I had to scrap mine too.

]]> Fri, 20 Nov 2015 22:43:47 +0000 https://www.soliforum.com/post/109957/#p109957 <![CDATA[Re: Stepper Disabled Error]]> https://www.soliforum.com/post/109892/#p109892 I have had this problem as well. Like you mentioned, LED shows 'stepper disabled', and my laptop control shows 'firmware unresponsive'. Not sure what caused it, but power off/on boots printer back again.

Though I am not as lucky as you are, after I power off/on, the print job doesn't just resume. so I basically have to scrap that round of print and start over with fingers-crossed.

I am also interested to see if anybody knows the cause of this occurrence and how to solve it.

]]> Fri, 20 Nov 2015 00:59:26 +0000 https://www.soliforum.com/post/109892/#p109892 <![CDATA[Stepper Disabled Error]]> https://www.soliforum.com/post/109845/#p109845 This is the first and only time I've had this one. I was two hours into a print and found it stopped with this error.  Anyone ever get this and know why it happens?  I powered it off/on and started the job again and it's running.  Weird.

Thanks.

]]> Thu, 19 Nov 2015 15:44:06 +0000 https://www.soliforum.com/post/109845/#p109845