https://www.soliforum.com/topic/12836/board-issue/ Mon, 16 Nov 2015 04:41:53 +0000 PunBB https://www.soliforum.com/post/109656/#p109656 I see in other post that some talk about using the Ramps 1.4. I looked into the kit with display, seems cheap in price. Has anyone else tried this board for a press, and if so how did it work for you?

]]> Mon, 16 Nov 2015 04:41:53 +0000 https://www.soliforum.com/post/109656/#p109656 https://www.soliforum.com/post/109654/#p109654 My extruder stepper motor stopped working. I swapped the wires from z axis to extruder drive and the extruder works and the z axis does not. I then put them back and just swapped which header the extruder and z axis motor where on and the problem always stays on which every motor is hooked the extruder header. I am pretty sure my board is bad, but I do not see a replacement board for it. Has anyone had to replace the board and if so where did you get the board?
Thanks in advance for your help.

]]> Mon, 16 Nov 2015 03:40:56 +0000 https://www.soliforum.com/post/109654/#p109654