SoliForum - 3D Printing Community — Anyone know if I can fix this?

Re: Anyone know if I can fix this?

null@example.com (craigunderhill) — Sun, 15 Nov 2015 02:01:26 +0000

By the way.. this isn't coming from the stepper motor. This is harness that plugs into the side of the extruder. I think it's for the thermistor and heating element.

Re: Anyone know if I can fix this?

null@example.com (craigunderhill) — Sat, 14 Nov 2015 23:08:41 +0000

Thanks, guys!

Landin81- Would I just crimp the wire that fell out and then stick it back in the harness? What about the piece that is still in there?

Carl_m1968- Do you know the proper name of the plastic harness? Maybe I could find just that on eBay.

Thanks again!

Re: Anyone know if I can fix this?

null@example.com (Landin81) — Sat, 14 Nov 2015 15:59:17 +0000

Think this would work...

http://www.ebay.com/itm/10pcs-2-54mm-Fe … xyGstR9eE6

Re: Anyone know if I can fix this?

null@example.com (carl_m1968) — Sat, 14 Nov 2015 07:42:38 +0000

craigunderhill wrote:

Can I buy a replacement end for this? I've looked all over the web and haven't found anything definitive. One wire broke, and I have it just sort of taped into place for now. Replacing the end would be easier than running all the wiring throughout the printer.
See attached image. Thanks.

Just look on ebay for stepper nema 17 stepper motors with harness and make sure they are the plug in type. Then you can just cut off the good one and splice it to your existing harness... or you can also get just a nema 17 harness as well on ebay.

Anyone know if I can fix this?

null@example.com (craigunderhill) — Sat, 14 Nov 2015 07:10:43 +0000

Can I buy a replacement end for this? I've looked all over the web and haven't found anything definitive. One wire broke, and I have it just sort of taped into place for now. Replacing the end would be easier than running all the wiring throughout the printer.

See attached image. Thanks.