<![CDATA[SoliForum - 3D Printing Community — Close up of hot end]]> https://www.soliforum.com/topic/12772/close-up-of-hot-end/ Sun, 08 Nov 2015 21:25:10 +0000 PunBB <![CDATA[Re: Close up of hot end]]> https://www.soliforum.com/post/109196/#p109196 Thanks. I just realized I can order a new ceramic heater for $4 on eBay. It's on the way. Thanks again!

]]> Sun, 08 Nov 2015 21:25:10 +0000 https://www.soliforum.com/post/109196/#p109196 <![CDATA[Re: Close up of hot end]]> https://www.soliforum.com/post/109173/#p109173 Like this? If you need a more in focus photo (I blame my iphone) I can use an actual camera, but the two wires just go into the heater cartridge, nothing special going on
http://i1194.photobucket.com/albums/aa376/pbcrazy96/E06B76E5-7527-4A45-9C3C-5FE6B22AA00C_zpsnn3lat4a.jpg
You can solder either wire to either spot on the heater cartridge, it doesn't make a difference. Or just buy a new heater off ebay

]]> Sun, 08 Nov 2015 17:26:32 +0000 https://www.soliforum.com/post/109173/#p109173 <![CDATA[Close up of hot end]]> https://www.soliforum.com/post/109158/#p109158 Can someone post a close up pic of where the red heater leads connect to the tip?
Mine came off. I probably can't fix but would love to try.

Thanks.

]]> Sun, 08 Nov 2015 14:50:34 +0000 https://www.soliforum.com/post/109158/#p109158