<![CDATA[SoliForum - 3D Printing Community — Solidoodle 2 sainsmart lcd upgrade]]> https://www.soliforum.com/topic/12630/solidoodle-2-sainsmart-lcd-upgrade/ Wed, 28 Oct 2015 23:04:37 +0000 PunBB <![CDATA[Re: Solidoodle 2 sainsmart lcd upgrade]]> https://www.soliforum.com/post/108465/#p108465 Here is a link on how to get a Panelolu to work with the Printrboard Rev D & E

http://blog.think3dprint3d.com/2013/04/ … board.html

]]> Wed, 28 Oct 2015 23:04:37 +0000 https://www.soliforum.com/post/108465/#p108465 <![CDATA[Re: Solidoodle 2 sainsmart lcd upgrade]]> https://www.soliforum.com/post/108459/#p108459 How do I verify that the firmware will work? It is a Rev E board. Not sure where to check for those headers? Thanks for the help by the way.

]]> Wed, 28 Oct 2015 21:02:42 +0000 https://www.soliforum.com/post/108459/#p108459 <![CDATA[Re: Solidoodle 2 sainsmart lcd upgrade]]> https://www.soliforum.com/post/108256/#p108256 pirvan wrote:

Assuming you still have the original Sanguino board, this will not plug directly into it.  This plugs into a RAMPS board or somthing similar.


If the board has an EXP1 and EXP2 header then this will work. The issue is if the firmware supports it.

]]> Sat, 24 Oct 2015 22:00:07 +0000 https://www.soliforum.com/post/108256/#p108256 <![CDATA[Re: Solidoodle 2 sainsmart lcd upgrade]]> https://www.soliforum.com/post/108251/#p108251 Assuming you still have the original Sanguino board, this will not plug directly into it.  This plugs into a RAMPS board or somthing similar.

]]> Sat, 24 Oct 2015 21:43:05 +0000 https://www.soliforum.com/post/108251/#p108251 <![CDATA[Solidoodle 2 sainsmart lcd upgrade]]> https://www.soliforum.com/post/108222/#p108222 Hey Guys,
I am new to the forum. I have been using a solidoodle gen 2 for a little over 2 years now. IT's been great, but I want to make it stand a lone. I have heard of people using panelolu2 and panelolu to upgrade the solidoodle 2. But I was wondering if anyone could tell me if the sainsmart lcd and sd card at the link below would also work. http://www.amazon.com/SainSmart-Control … rt+sd+card

I ask because this is less than half the cost of the panelolu, and free shipping. I have a Rev E motherboard. I'm sure it will take some fidgeting to get it working, I was just wondering if anyone here could tell me if it would work for certain. I called Solidoodle support this afternoon, and they recommended I post this question here. Hope that is okay. Thanks in advance for the help.
SM

]]> Sat, 24 Oct 2015 02:49:46 +0000 https://www.soliforum.com/post/108222/#p108222