<![CDATA[SoliForum - 3D Printing Community — Table coupler/stepper motor spindle]]> https://www.soliforum.com/topic/12523/table-couplerstepper-motor-spindle/ Sat, 10 Oct 2015 22:18:33 +0000 PunBB <![CDATA[Re: Table coupler/stepper motor spindle]]> https://www.soliforum.com/post/107344/#p107344 I had a wobble problem, but for me it was attributed to the flatness of the printed table.  Specifically, the mating pieces were not totally flat.  I tried to file it and it made it a little better, but eventually I stuck a small piece of paper between the coupler and the table to wedge that side up.  Worked fine.

Oh and I must be using the modified two screw coupler.  It is a really tight fit on my shaft.

http://www.soliforum.com/topic/11384/turntable-wobble/

]]> Sat, 10 Oct 2015 22:18:33 +0000 https://www.soliforum.com/post/107344/#p107344 <![CDATA[Re: Table coupler/stepper motor spindle]]> https://www.soliforum.com/post/107336/#p107336 Seek and you will find.

Search for "turntable wobble"

]]> Sat, 10 Oct 2015 18:58:46 +0000 https://www.soliforum.com/post/107336/#p107336 <![CDATA[Table coupler/stepper motor spindle]]> https://www.soliforum.com/post/107324/#p107324 The stepper motor has a round spindle, so on my assembled unit the table and tilt on the axis of the two screws that hold the table coupler onto the stepper motor spindle.  Does anyone have a good solution for stabilizing this?

]]> Sat, 10 Oct 2015 16:26:58 +0000 https://www.soliforum.com/post/107324/#p107324