<![CDATA[SoliForum - 3D Printing Community — Could you diagnose this result?]]> https://www.soliforum.com/topic/12414/could-you-diagnose-this-result/ Tue, 29 Sep 2015 11:28:48 +0000 PunBB <![CDATA[Re: Could you diagnose this result?]]> https://www.soliforum.com/post/106467/#p106467 batmaster wrote:

that edge is probably where the extruder either leaves or enters the part between features and because your temperature is too high its leaving ooze.

Ok, then I have to set a bit down the extruder temperature, currently 230ºC

Thanks!!

]]> Tue, 29 Sep 2015 11:28:48 +0000 https://www.soliforum.com/post/106467/#p106467 <![CDATA[Re: Could you diagnose this result?]]> https://www.soliforum.com/post/106430/#p106430 EDIT - sorry it double posted

]]> Mon, 28 Sep 2015 20:48:03 +0000 https://www.soliforum.com/post/106430/#p106430 <![CDATA[Re: Could you diagnose this result?]]> https://www.soliforum.com/post/106429/#p106429 that edge is probably where the extruder either leaves or enters the part between features and because your temperature is too high its leaving ooze.

]]> Mon, 28 Sep 2015 20:47:56 +0000 https://www.soliforum.com/post/106429/#p106429 <![CDATA[Re: Could you diagnose this result?]]> https://www.soliforum.com/post/106426/#p106426 Yes, it seems that. But only affecting an edge section?

]]> Mon, 28 Sep 2015 19:12:00 +0000 https://www.soliforum.com/post/106426/#p106426 <![CDATA[Re: Could you diagnose this result?]]> https://www.soliforum.com/post/106415/#p106415 Temprature is too high.

]]> Mon, 28 Sep 2015 18:14:49 +0000 https://www.soliforum.com/post/106415/#p106415 <![CDATA[Could you diagnose this result?]]> https://www.soliforum.com/post/106413/#p106413 What is wrong to obtain that edge?

http://soliforum.com/i/?j1k2cQ0.jpg

]]> Mon, 28 Sep 2015 18:04:08 +0000 https://www.soliforum.com/post/106413/#p106413