<![CDATA[SoliForum - 3D Printing Community — settings]]> https://www.soliforum.com/topic/12404/settings/ Mon, 28 Sep 2015 01:25:30 +0000 PunBB <![CDATA[Re: settings]]> https://www.soliforum.com/post/106355/#p106355 The one with Repetier v1.5.6 is the version is 1.2.2 what software you recommend me

]]> Mon, 28 Sep 2015 01:25:30 +0000 https://www.soliforum.com/post/106355/#p106355 <![CDATA[Re: settings]]> https://www.soliforum.com/post/106351/#p106351 You have bigger problems than what slicer to use.

]]> Sun, 27 Sep 2015 23:18:36 +0000 https://www.soliforum.com/post/106351/#p106351 <![CDATA[Re: settings]]> https://www.soliforum.com/post/106340/#p106340 i use slic3r do you know something better to print and slice

]]> Sun, 27 Sep 2015 21:25:20 +0000 https://www.soliforum.com/post/106340/#p106340 <![CDATA[Re: settings]]> https://www.soliforum.com/post/106339/#p106339 http://soliforum.com/i/?1cKOy7A.jpg

]]> Sun, 27 Sep 2015 21:23:33 +0000 https://www.soliforum.com/post/106339/#p106339 <![CDATA[Re: settings]]> https://www.soliforum.com/post/106338/#p106338 Thank you i will try to post a picture because i can't finish nothing stars fine and half way stays on the air trying to print and the print the i got so far is small, got couple of good solid lines but missing spots.

]]> Sun, 27 Sep 2015 20:38:14 +0000 https://www.soliforum.com/post/106338/#p106338 <![CDATA[Re: settings]]> https://www.soliforum.com/post/106337/#p106337 It would help a bit if you could post a picture or two of the quality.
After installing the E3D, you want to recalibrate the extruder, adjust your VREF for E, and be certain the fan is turning.

As long as you assembled correctly and made the proper adjustments in the firmware, this should be a fairly straightforward fix.

]]> Sun, 27 Sep 2015 19:05:52 +0000 https://www.soliforum.com/post/106337/#p106337 <![CDATA[settings]]> https://www.soliforum.com/post/106333/#p106333 Hi Guy's i need help with slic3r settings after i install E3D hotend on my solidoodle 2 i did the changes on the marlin firmware but my prints are not looking so good they look rough and to much thick lines please help

]]> Sun, 27 Sep 2015 18:26:39 +0000 https://www.soliforum.com/post/106333/#p106333