<![CDATA[SoliForum - 3D Printing Community — Is it possible?]]> https://www.soliforum.com/topic/12314/is-it-possible/ Fri, 18 Sep 2015 06:59:58 +0000 PunBB <![CDATA[Re: Is it possible?]]> https://www.soliforum.com/post/105659/#p105659 Or flash repetier and you can do away with the 2nd extruder altogether.

]]> Fri, 18 Sep 2015 06:59:58 +0000 https://www.soliforum.com/post/105659/#p105659 <![CDATA[Re: Is it possible?]]> https://www.soliforum.com/post/105628/#p105628 iceman72 wrote:

Can I just unscrew the second hot end and unwire it?

You would need to leave a the hotend heater and thermistor attached or the machine would fail the power up self test. It looks for both devices to be present and connected at power up. You might can get away with disconnecting the heater, but the thermistor absolutely must remain attached even if you are not using that channel it still looks for it at power up since the firmware knows there should be two.

]]> Fri, 18 Sep 2015 02:32:55 +0000 https://www.soliforum.com/post/105628/#p105628 <![CDATA[Re: Is it possible?]]> https://www.soliforum.com/post/105627/#p105627 Can I just unscrew the second hot end and unwire it?

]]> Fri, 18 Sep 2015 02:24:36 +0000 https://www.soliforum.com/post/105627/#p105627 <![CDATA[Re: Is it possible?]]> https://www.soliforum.com/post/105592/#p105592 I would say yes it is possible you would just have to do a modified carriage. You can go with a pico or e3d hotend.

]]> Thu, 17 Sep 2015 14:34:10 +0000 https://www.soliforum.com/post/105592/#p105592 <![CDATA[Re: Is it possible?]]> https://www.soliforum.com/post/105587/#p105587 As I was looking at my original stock print heads. It looks like I can totally take the second head off.  Would that cause the printer to not print? I know this thing looks for everything on boot up and mine is basically stock. Just curious. I am so sick of the dragging of the second head. Its driving me nuts!

]]> Thu, 17 Sep 2015 12:50:47 +0000 https://www.soliforum.com/post/105587/#p105587 <![CDATA[Is it possible?]]> https://www.soliforum.com/post/105586/#p105586 Hey folks I have a Da Vinci 2.0. I would love nothing more than to take out the second print head. Is that possible? I really think it causes more problems than anything. Not to mention I almost never use it.

]]> Thu, 17 Sep 2015 12:27:39 +0000 https://www.soliforum.com/post/105586/#p105586