<![CDATA[SoliForum - 3D Printing Community — Top open censor?]]> https://www.soliforum.com/topic/12227/top-open-censor/ Sat, 05 Sep 2015 13:08:10 +0000 PunBB <![CDATA[Re: Top open censor?]]> https://www.soliforum.com/post/104858/#p104858 Many thanks guys. I tossed a piece of paper in the back and thats cool. I really don't want to flash as of yet because its still new and under warranty. Although I do wish I could just go back to 2.0J.

]]> Sat, 05 Sep 2015 13:08:10 +0000 https://www.soliforum.com/post/104858/#p104858 <![CDATA[Re: Top open censor?]]> https://www.soliforum.com/post/104825/#p104825 If you have flashed it to repetier you can also turn off the sensor

]]> Fri, 04 Sep 2015 21:29:01 +0000 https://www.soliforum.com/post/104825/#p104825 <![CDATA[Re: Top open censor?]]> https://www.soliforum.com/post/104816/#p104816 iceman72 wrote:

I would like to use my 3rd party filament with my 2.0. When I keep the top open it says "Top Door Open". How can I trick this?

Just stick a piece of paper in it. It uses the same sensor through the machine. It is located in the right back of the door seal.

]]> Fri, 04 Sep 2015 18:08:41 +0000 https://www.soliforum.com/post/104816/#p104816 <![CDATA[Top open censor?]]> https://www.soliforum.com/post/104813/#p104813 I would like to use my 3rd party filament with my 2.0. When I keep the top open it says "Top Door Open". How can I trick this?

]]> Fri, 04 Sep 2015 16:52:25 +0000 https://www.soliforum.com/post/104813/#p104813