SoliForum - 3D Printing Community — Original thermistor + E3d v6 ?

Re: Original thermistor + E3d v6 ?

null@example.com (jagowilson) — Sun, 06 Sep 2015 02:29:53 +0000

bubblefrog wrote:

elmoret wrote:
Its too big, it won't fit. You can drill out the hole in the heater block if you want.
I think I managed to program the press using the "Bootloader method", is there any way of checking if the programming was successful (The printer works after programming, but I dont know if the firmware has changed)

The thermistor should read ambient temperature on start. if you increased the max temp for the extruder, you should be able to reach the new max.

Re: Original thermistor + E3d v6 ?

null@example.com (bubblefrog) — Sat, 05 Sep 2015 09:54:27 +0000

elmoret wrote:

Its too big, it won't fit. You can drill out the hole in the heater block if you want.

I think I managed to program the press using the "Bootloader method", is there any way of checking if the programming was successful (The printer works after programming, but I dont know if the firmware has changed)

Re: Original thermistor + E3d v6 ?

null@example.com (jagowilson) — Sat, 05 Sep 2015 03:11:56 +0000

if the press won't let you heat to 280, you will still have to wait for the programmer. don't tighten it too cold, it will loosen up and leak plastic.

Re: Original thermistor + E3d v6 ?

null@example.com (elmoret) — Wed, 02 Sep 2015 21:29:02 +0000

Its too big, it won't fit. You can drill out the hole in the heater block if you want.

Original thermistor + E3d v6 ?

null@example.com (bubblefrog) — Wed, 02 Sep 2015 20:26:41 +0000

As the title says I have a small question, can I use the original thermistor that came with my press in combination with e3d v6 until my isp programmer arrives?

I know that the temperatures may not be accurate but is it possible without harming my press och e3d?

//Bubblefrog