<![CDATA[SoliForum - 3D Printing Community — Outer shell pulling away]]> https://www.soliforum.com/topic/12186/outer-shell-pulling-away/ Sun, 30 Aug 2015 19:05:26 +0000 PunBB <![CDATA[Re: Outer shell pulling away]]> https://www.soliforum.com/post/104506/#p104506 Make sure you are tuned in ie steps per mm on extrusion extrusion multiplier nozzle setting etc.
Yes a common problem for new machines until you get the settings down.
your slicer program may also have an overlap feature something called infill perimeter overlap or the like 
You can boost this setting if all else fails.

Personally I would add another shell or two  and back the infill down to 25 % this will depend on the use of the item 100% usually recommended for structural stuff. 
Tin

]]> Sun, 30 Aug 2015 19:05:26 +0000 https://www.soliforum.com/post/104506/#p104506 <![CDATA[Re: Outer shell pulling away]]> https://www.soliforum.com/post/104496/#p104496 I had this problem starting out. Check your nozzle settings and add 20% to what size your nozzle is.
Eg: .4 nozzle=.48 setting.

Also be sure you have checked the filament diameter and entered/saved properly.

]]> Sun, 30 Aug 2015 14:40:39 +0000 https://www.soliforum.com/post/104496/#p104496 <![CDATA[Re: Outer shell pulling away]]> https://www.soliforum.com/post/104495/#p104495 Can you post a picture of what is happening?

]]> Sun, 30 Aug 2015 14:18:56 +0000 https://www.soliforum.com/post/104495/#p104495 <![CDATA[Outer shell pulling away]]> https://www.soliforum.com/post/104493/#p104493 Hello 3D pros.

I am printing a flat plate on a Ultimaker 2 and the outer shell it always seems to peel away. I am pritning on PLA, I have an infill of 40% and i am going for a standard 2 shells.

Any advice?

]]> Sun, 30 Aug 2015 13:28:19 +0000 https://www.soliforum.com/post/104493/#p104493