<![CDATA[SoliForum - 3D Printing Community — Extruder]]> https://www.soliforum.com/topic/12177/extruder/ Tue, 08 Sep 2015 01:00:29 +0000 PunBB <![CDATA[Re: Extruder]]> https://www.soliforum.com/post/104990/#p104990 trayracing wrote:

Does the filament bulge or kink just before it enters the heat break?


No

]]> Tue, 08 Sep 2015 01:00:29 +0000 https://www.soliforum.com/post/104990/#p104990 <![CDATA[Re: Extruder]]> https://www.soliforum.com/post/104989/#p104989 widespreaddeadhead wrote:

What type of filament are you using, ABS or PLA?

  abs

]]> Tue, 08 Sep 2015 01:00:07 +0000 https://www.soliforum.com/post/104989/#p104989 <![CDATA[Re: Extruder]]> https://www.soliforum.com/post/104552/#p104552 What type of filament are you using, ABS or PLA?

]]> Mon, 31 Aug 2015 14:27:36 +0000 https://www.soliforum.com/post/104552/#p104552 <![CDATA[Re: Extruder]]> https://www.soliforum.com/post/104492/#p104492 Does the filament bulge or kink just before it enters the heat break?

]]> Sun, 30 Aug 2015 13:08:36 +0000 https://www.soliforum.com/post/104492/#p104492 <![CDATA[Re: Extruder]]> https://www.soliforum.com/post/104446/#p104446 Dip the end of filament in mineral oil eery once in a wgile this solved almost all provlems for me
Also make sure that the spool turns smoothly with minimal friction

]]> Sat, 29 Aug 2015 17:47:46 +0000 https://www.soliforum.com/post/104446/#p104446 <![CDATA[Extruder]]> https://www.soliforum.com/post/104445/#p104445 Hello,

Everything time I start a print (230 temp and filament)  about halfway through every print it's starts clicking and gets clogged.  I stop the print and push a 1.5 mm Allen wrench through it to unclog.  Filament comes out and I try the print again.  No luck.  What should u do

]]> Sat, 29 Aug 2015 17:41:00 +0000 https://www.soliforum.com/post/104445/#p104445