<![CDATA[SoliForum - 3D Printing Community — Up in Smoke]]> https://www.soliforum.com/topic/12135/up-in-smoke/ Mon, 24 Aug 2015 16:56:21 +0000 PunBB <![CDATA[Re: Up in Smoke]]> https://www.soliforum.com/post/104115/#p104115 the real question is whether it damaged your main board when it shorted out.

]]> Mon, 24 Aug 2015 16:56:21 +0000 https://www.soliforum.com/post/104115/#p104115 <![CDATA[Up in Smoke]]> https://www.soliforum.com/post/104113/#p104113 I run a 1.0 with repetier and Simplify3D. While printing I received a message on the display that said filament is out, load filament. Although, the filament was not out. It paused, then moved to home position in x and y (typical for reloading filament), and then one of the wires to the nozzle circuit board overheated, melted the insulation and smoked. I unplugged as soon as I saw the smoke. It appears that the board in the nozzle went bad (not sure why that is as of yet) and was giving a faulty read that the filament was out. Attached are some pictures.

Has anyone experienced this?

What I plan on doing is replacing the entire nozzle and find a new wire harness for that particular plug. Any ideas where I might be able to find one close to what these are off the self?

Nozzle circuit board:
http://soliforum.com/i/?C3dcQkc.jpg

Connection to Arduino board:
http://soliforum.com/i/?OmsUHZ1.jpg

Connection to nozzle board:
http://soliforum.com/i/?w5ptxCf.jpg

]]> Mon, 24 Aug 2015 15:28:08 +0000 https://www.soliforum.com/post/104113/#p104113