<![CDATA[SoliForum - 3D Printing Community — Z-Axis Calibration for Octoprint after installing E3Dv6 hotend]]> https://www.soliforum.com/topic/12070/zaxis-calibration-for-octoprint-after-installing-e3dv6-hotend/ Fri, 14 Aug 2015 18:24:36 +0000 PunBB <![CDATA[Z-Axis Calibration for Octoprint after installing E3Dv6 hotend]]> https://www.soliforum.com/post/103571/#p103571 Very recently I finished converting to the E3Dv6 hotend with the Bowden mounted extruder motor.

I used SoliPrint to perform the z-axis calibration. After that I could see that it had sent M851 with the new Z offset and when I used M500 the new value was shown. Printing works with Soliprint. However if I print by running Slic3r and Octoprint then my Z offset isn't used.

Before the conversion I was printing with OctoPi. It's possible that my Z offset wasn't used and I didn't notice but I did have several successful or almost-successful prints.

Some other posts refer to M212 in Marlin firmware for this purpose. Do I need to do that as well? Or maybe there's some G-code preamble that I should add to my slicer?

]]> Fri, 14 Aug 2015 18:24:36 +0000 https://www.soliforum.com/post/103571/#p103571