<![CDATA[SoliForum - 3D Printing Community — Extruder Stepper Replacement]]> https://www.soliforum.com/topic/12005/extruder-stepper-replacement/ Sun, 09 Aug 2015 23:28:15 +0000 PunBB <![CDATA[Re: Extruder Stepper Replacement]]> https://www.soliforum.com/post/103267/#p103267 Cheers guys.

]]> Sun, 09 Aug 2015 23:28:15 +0000 https://www.soliforum.com/post/103267/#p103267 <![CDATA[Re: Extruder Stepper Replacement]]> https://www.soliforum.com/post/103229/#p103229 ^What wardjr said...

Here is a good resource as well:

http://www.omc-stepperonline.com/steppe … -1_21.html

I also do not know the spec of the current motor, but a 0.9 stepper is a good idea.  Between that and the smaller pitch diameter of the Hobbed Goblin you will get much higher precision.

]]> Sun, 09 Aug 2015 15:37:16 +0000 https://www.soliforum.com/post/103229/#p103229 <![CDATA[Re: Extruder Stepper Replacement]]> https://www.soliforum.com/post/103224/#p103224 I do not know the specs for the stock motors.  They are heavier than you'd think and produce very little torque for their size.  My advice would be look for the highest torque motor you can find with the same/similar dimensions.

]]> Sun, 09 Aug 2015 14:29:58 +0000 https://www.soliforum.com/post/103224/#p103224 <![CDATA[Extruder Stepper Replacement]]> https://www.soliforum.com/post/103214/#p103214 So my Hobb Goblin arrived and then I snapped the end of an allen key off in the grub screw on the stock SD2 extruder gear sad

Tried drilling it out, but it's a real pig. So I might just get a replacement.

My first thought is this:

http://e3d-online.com/Electrical/Steppe … MA17-40Ncm

I also found this locally

http://www.makershop.co.nz/motors/stepper_42BYGHM809

But that might be a bit heavy for already overworked X carriage stepper.

Any thoughts? What would you choose? Does anyone have the specs for the Extruder Stepper for an SD2?

]]> Sun, 09 Aug 2015 07:25:12 +0000 https://www.soliforum.com/post/103214/#p103214