https://www.soliforum.com/topic/11820/possible-firmware-issue/ Mon, 20 Jul 2015 03:30:23 +0000 PunBB https://www.soliforum.com/post/101544/#p101544 Thanks for the idea, but I was able to send homing commands to the printer using the host. I have connected with Repetier Host and Soliprint.

]]> Mon, 20 Jul 2015 03:30:23 +0000 https://www.soliforum.com/post/101544/#p101544 https://www.soliforum.com/post/101542/#p101542 The host does not connect automatically, you have to click the button that says connect and confirm it turns green. Then you should also active temperature feed back in the host as well.

]]> Mon, 20 Jul 2015 03:25:28 +0000 https://www.soliforum.com/post/101542/#p101542 https://www.soliforum.com/post/101541/#p101541 Carl, I don't follow. Isn't the host the printing software? Perhaps the USB cable is loose or a wire in the harness to the board is loose?

]]> Mon, 20 Jul 2015 03:00:29 +0000 https://www.soliforum.com/post/101541/#p101541 https://www.soliforum.com/post/101540/#p101540 Are you making sure you are connected in your host?

]]> Mon, 20 Jul 2015 02:54:58 +0000 https://www.soliforum.com/post/101540/#p101540 https://www.soliforum.com/post/101537/#p101537 Hey Gang,
Has anyone else had the issue of sending a print to the printer and you see the g-code sent line by line but none of the motors run?
Recently I repaired the z-stepper motor connector, one that I'm sure many of you are familiar with since there is not a proper amount of strain relief in the harness going to the printer head.
Also note that I can home all axis and run the z-calibration but there is no manual control using RH or the Soliprint.
Thanks for commenting,
~Codum

]]> Mon, 20 Jul 2015 02:06:52 +0000 https://www.soliforum.com/post/101537/#p101537