<![CDATA[SoliForum - 3D Printing Community — Can I use the LED lights on a reprap 12v ?]]> https://www.soliforum.com/topic/11812/can-i-use-the-led-lights-on-a-reprap-12v/ Sun, 02 Aug 2015 00:59:40 +0000 PunBB <![CDATA[Re: Can I use the LED lights on a reprap 12v ?]]> https://www.soliforum.com/post/102689/#p102689 Well you can if you use two resisters one in series the other in parallel to create the correct  voltage drop.

However Carl's solution to buy one that is the right voltage is simpler and will most likely use less power any way.

]]> Sun, 02 Aug 2015 00:59:40 +0000 https://www.soliforum.com/post/102689/#p102689 <![CDATA[Re: Can I use the LED lights on a reprap 12v ?]]> https://www.soliforum.com/post/102589/#p102589 The LED strip in a Da Vinci runs on 5 volts. So no you can't use them. The Da Vinci is kind of unique in that it actually uses three different voltages in it's system. It uses 12v, 5v, and 3.3v. But the LED strip is 5 volts. Just check ebay, you can buy 12 volt strips for dirt cheap and cut them to any length you need.

]]> Fri, 31 Jul 2015 17:47:46 +0000 https://www.soliforum.com/post/102589/#p102589 <![CDATA[Re: Can I use the LED lights on a reprap 12v ?]]> https://www.soliforum.com/post/102588/#p102588 hello? any know the answer?

]]> Fri, 31 Jul 2015 17:37:27 +0000 https://www.soliforum.com/post/102588/#p102588 <![CDATA[Re: Can I use the LED lights on a reprap 12v ?]]> https://www.soliforum.com/post/101532/#p101532 Not sure what you mean? Will the led work on 12v?

]]> Sun, 19 Jul 2015 22:13:50 +0000 https://www.soliforum.com/post/101532/#p101532 <![CDATA[Re: Can I use the LED lights on a reprap 12v ?]]> https://www.soliforum.com/post/101530/#p101530 I have a 1.0 on stock but I just picked up a 12V line and then split the wire and soldered back together. also put a set of 3 rocker switches in so I can control them and other stuff

]]> Sun, 19 Jul 2015 21:35:03 +0000 https://www.soliforum.com/post/101530/#p101530 <![CDATA[Can I use the LED lights on a reprap 12v ?]]> https://www.soliforum.com/post/101487/#p101487 Can I use the LED lights on my davinci 2.0 on a reprap 12 power supply? I see the led plug has three wires

]]> Sat, 18 Jul 2015 20:43:45 +0000 https://www.soliforum.com/post/101487/#p101487