<![CDATA[SoliForum - 3D Printing Community — Help! "Filament Jam" but samples work!]]> https://www.soliforum.com/topic/11774/help-filament-jam-but-samples-work/ Fri, 17 Jul 2015 20:29:50 +0000 PunBB <![CDATA[Re: Help! "Filament Jam" but samples work!]]> https://www.soliforum.com/post/101409/#p101409 well not the same issue but solution MAY work.
I had an issue where the print bed would not heat if I used the XYZ ware but the samples printed fine.
I uninstalled everything thru windows, then I searched the registry for every key related to XYZ and manually deleted them.
I then reinstalled all software from the disk, followed by updating the software thru the net.
It worked after that.

That said, the last firmware update bricked my printer and I shipped it back under warranty for replacement.
So there is that.

]]> Fri, 17 Jul 2015 20:29:50 +0000 https://www.soliforum.com/post/101409/#p101409 <![CDATA[Help! "Filament Jam" but samples work!]]> https://www.soliforum.com/post/101201/#p101201 Hi, suddenly I've been getting a "Filament Jam" error in my DaVinci 2.0A.
I unloaded and loaded my cartridges again and I have the same error.
However, then I tried printing a demo through the menu in the printer and it printed just fine, and the error only comes up if I try to print using XYZWare.
Anyone know what to do?
Thanks

]]> Wed, 15 Jul 2015 08:39:31 +0000 https://www.soliforum.com/post/101201/#p101201