<![CDATA[SoliForum - 3D Printing Community — problem with firmware]]> https://www.soliforum.com/topic/11720/problem-with-firmware/ Tue, 14 Jul 2015 17:45:44 +0000 PunBB <![CDATA[Re: problem with firmware]]> https://www.soliforum.com/post/101107/#p101107 mferronatto wrote:

Hello, I found another post with this problem, so I decided to ask.
While updating the firmware of my printer XYZPrinting duo, there was a power surge in my region and the printer turned off after re-power the printer does not turn on and two bars appear on the printer display, after reading some materials saw that you can do not turn off during the upgrade.
Now the big question, is no fix this problem?
How should I proceed?

Thank you for your attention

I had to ship mine back to them ...but im under warranty.
It probably was not a power surge, the XYZ software froze mid upgrade and bricked the printer.

]]> Tue, 14 Jul 2015 17:45:44 +0000 https://www.soliforum.com/post/101107/#p101107 <![CDATA[Re: problem with firmware]]> https://www.soliforum.com/post/100763/#p100763 it is the "jail break" of the davinci.

If you don't want to do that you may need to contact xyz on help on trying to reapply your firmware.

Basically repetier 9.2 is a open source firmware and the repeteier host is the  printing program

]]> Thu, 09 Jul 2015 23:23:22 +0000 https://www.soliforum.com/post/100763/#p100763 <![CDATA[Re: problem with firmware]]> https://www.soliforum.com/post/100758/#p100758 what is repetier .92?

]]> Thu, 09 Jul 2015 21:06:41 +0000 https://www.soliforum.com/post/100758/#p100758 <![CDATA[Re: problem with firmware]]> https://www.soliforum.com/post/100748/#p100748 one of 2 thing's have to happen now try to reinstall the upgrade or go to repetier .92

]]> Thu, 09 Jul 2015 17:57:21 +0000 https://www.soliforum.com/post/100748/#p100748 <![CDATA[problem with firmware]]> https://www.soliforum.com/post/100739/#p100739 Hello, I found another post with this problem, so I decided to ask.
While updating the firmware of my printer XYZPrinting duo, there was a power surge in my region and the printer turned off after re-power the printer does not turn on and two bars appear on the printer display, after reading some materials saw that you can do not turn off during the upgrade.
Now the big question, is no fix this problem?
How should I proceed?

Thank you for your attention

]]> Thu, 09 Jul 2015 15:25:57 +0000 https://www.soliforum.com/post/100739/#p100739