SoliForum - 3D Printing Community — display time remaining ?

Re: display time remaining ?

null@example.com (luc) — Sat, 27 Jun 2015 00:35:26 +0000

printing from Repetier host display printing progression / remaining time on printer LCD
printing from Simplify3D do not display printing progression / remaining time on printer LCD (at least until 2.22, no idea if 3.0 do it now)
printing from SD card display printing progression / remaining time on printer LCD

Re: display time remaining ?

null@example.com (carl_m1968) — Fri, 26 Jun 2015 21:37:10 +0000

Just a note as well, the time remaining has an error rate of +/- 30 to 45 minutes as it is computed rather than tracked real time.

After checking, Repetier .92 should show time remaining but again that is estimated and is usually off by 20%.

I forgot I was running Marlin as I have converted to a RAMPS controller on my 1.0 so it was not showing time remaining nor do I really track it since it prints at night while I am asleep and when I am doing other things. When it gets done, it gets done.

Re: display time remaining ?

null@example.com (Dominick) — Fri, 26 Jun 2015 21:03:10 +0000

For me, if you are on windows it will display it on the printer's LCD, I have a dual boot so I mostly stay on Mac which does not.

Besides I'm not one who dwells on the time remaining. Start the print, make sure it's running good, then leave it.

Re: display time remaining ?

null@example.com (efes) — Fri, 26 Jun 2015 20:50:50 +0000

OK thank you! print with its SD Card possible?

Re: display time remaining ?

null@example.com (carl_m1968) — Fri, 26 Jun 2015 20:47:44 +0000

Not with repetier firmware. It is displayed in the host however.

display time remaining ?

null@example.com (efes) — Fri, 26 Jun 2015 19:41:15 +0000

hello,
it is possible to display the time remaining on the lcd of DaVinci 1.0?
if so how?
thank you

firmware repetier