<![CDATA[SoliForum - 3D Printing Community — s3d configured ?]]> https://www.soliforum.com/topic/11590/s3d-configured/ Wed, 24 Jun 2015 08:53:30 +0000 PunBB <![CDATA[Re: s3d configured ?]]> https://www.soliforum.com/post/99800/#p99800 First of all, your Extrusion Width is set to 0.50...it should be 0.48; then follow the steps outlined here:

https://solidoodletips.wordpress.com/20 … flow-rate/

The above was done for a 0.35 dia. nozzle, but the calculations / adjustment procedures are the same...

]]> Wed, 24 Jun 2015 08:53:30 +0000 https://www.soliforum.com/post/99800/#p99800 <![CDATA[Re: s3d configured ?]]> https://www.soliforum.com/post/99798/#p99798 1.10 works well for me.

]]> Wed, 24 Jun 2015 07:10:51 +0000 https://www.soliforum.com/post/99798/#p99798 <![CDATA[Re: s3d configured ?]]> https://www.soliforum.com/post/99765/#p99765 IronMan wrote:

Seems like you are under-extruding a bit...try bumping up your Extrusion Multiplier...

Also, you should do a single-wall calibration cube every time you switch filament.

I have 1,0 I need to increase maximum how much?

]]> Tue, 23 Jun 2015 22:25:22 +0000 https://www.soliforum.com/post/99765/#p99765 <![CDATA[Re: s3d configured ?]]> https://www.soliforum.com/post/99753/#p99753 Seems like you are under-extruding a bit...try bumping up your Extrusion Multiplier...

Also, you should do a single-wall calibration cube every time you switch filament.

]]> Tue, 23 Jun 2015 20:49:08 +0000 https://www.soliforum.com/post/99753/#p99753 <![CDATA[s3d configured ?]]> https://www.soliforum.com/post/99749/#p99749 hello, I use S3D shoulders and neck not very well printed, how well configured? thank you

attach FFF setup s3d

]]> Tue, 23 Jun 2015 19:59:35 +0000 https://www.soliforum.com/post/99749/#p99749