https://www.soliforum.com/topic/11486/davinci-duo-20a-simplofy3d-temp-settings-not-sticking/ Sun, 14 Jun 2015 20:07:47 +0000 PunBB https://www.soliforum.com/post/98917/#p98917 I'm using Simplify3D with my unmodified 2.0A. I changed the temp settings to 90F for the bed and 230F for the hot end. When a job is started the machine warms to those temperatures, but then the extruder drops down to 215 and stays there. This is causing issues with delamination. I had one print where the temp actually stayed at 230F, and I didn't have any layer delamination. All the other prints have dropped and all of them delaminate. Any clues as to what I may be doing wrong?

]]> Sun, 14 Jun 2015 20:07:47 +0000 https://www.soliforum.com/post/98917/#p98917