<![CDATA[SoliForum - 3D Printing Community — Extruder Cabling on SD4]]> https://www.soliforum.com/topic/11372/extruder-cabling-on-sd4/ Thu, 04 Jun 2015 01:44:56 +0000 PunBB <![CDATA[Re: Extruder Cabling on SD4]]> https://www.soliforum.com/post/97882/#p97882 TickTock wrote:

Check this out:

http://www.thingiverse.com/thing:104817

Yeah, that's what I was referring to when I was talking about running cables through cable chain. However, with the SD4, the electronics board is located somewhere else, making it a bit more annoying to keep everything neat with chain.

]]> Thu, 04 Jun 2015 01:44:56 +0000 https://www.soliforum.com/post/97882/#p97882 <![CDATA[Re: Extruder Cabling on SD4]]> https://www.soliforum.com/post/97832/#p97832 Check this out:

http://www.thingiverse.com/thing:104817

]]> Wed, 03 Jun 2015 17:13:47 +0000 https://www.soliforum.com/post/97832/#p97832 <![CDATA[Extruder Cabling on SD4]]> https://www.soliforum.com/post/97813/#p97813 Hey, I was wondering if anyone had a good solution to organizing the cabling coming out of the X motor and extruder. I'd really like to be able to get it completely out of the way(especially when it is all the way at the front of the printer), but haven't been able to find a good way especially with the electronics box being in the lower corner of the printer.

I was thinking of extending the wires and running it through some cable chain, but even then, the wires would need to be ran back down the the bottom of the printer to the board.

Does anyone have any better solutions to wiring on their SD4?

]]> Wed, 03 Jun 2015 07:36:12 +0000 https://www.soliforum.com/post/97813/#p97813