https://www.soliforum.com/topic/11342/edges-bowing-inwards/ Thu, 04 Jun 2015 18:05:16 +0000 PunBB https://www.soliforum.com/post/97936/#p97936 Too much radiated heat. Either lower your temps, or print several objects simultaneously or use a layer cooling fan (can bring other issues with ABS).

]]> Thu, 04 Jun 2015 18:05:16 +0000 https://www.soliforum.com/post/97936/#p97936 https://www.soliforum.com/post/97538/#p97538 I had the same problem.  I had to look twice to make sure this wasnt my post a few weeks back.
I have the same black hatchbox (although does same for other colours too).
lower the bed temp to 65-70C and you're golden.

]]> Sun, 31 May 2015 05:14:31 +0000 https://www.soliforum.com/post/97538/#p97538 https://www.soliforum.com/post/97537/#p97537 I am using Black Hatchbox ABS @ 215 and bed 90 degrees. The top of the print is perfectly flat and the bottom is not warping up. What should I do to stop this? I did try lowering my printing speed and it produced the same results. As well as increasing temp, which had the same results, until it became stringy @ 230+.

]]> Sun, 31 May 2015 04:50:45 +0000 https://www.soliforum.com/post/97537/#p97537