<![CDATA[SoliForum - 3D Printing Community — 4 prints, loose belt..?]]> https://www.soliforum.com/topic/11340/4-prints-loose-belt/ Sun, 31 May 2015 03:19:32 +0000 PunBB <![CDATA[Re: 4 prints, loose belt..?]]> https://www.soliforum.com/post/97535/#p97535 Possibly a broken mount in the back or front on the right side?

http://www.elproducts.com/chucks-blog/d … eplacement

]]> Sun, 31 May 2015 03:19:32 +0000 https://www.soliforum.com/post/97535/#p97535 <![CDATA[4 prints, loose belt..?]]> https://www.soliforum.com/post/97532/#p97532 Hi all,

So I'm a new owner of a Da Vinci 1.0a, done around 4 prints and I've noticed that sometimes the right-hand belt is dropping down and showing some slack. However, this is not constant and sometimes the belt seems to be just as taught as the others, anyone else come across this? So after noticing this and it not actually seeming to affect prints, now it has started slipping and producing some horrific results (obviously, see below).

http://soliforum.com/i/?UP1aiFI.jpg

I would appreciate any advice from someone who has knowledge/has experienced this before, is it merely a loose belt? Could something else be at fault - which would explain the belt not permanently showing slack.

Thanks in advance

]]> Sat, 30 May 2015 23:24:35 +0000 https://www.soliforum.com/post/97532/#p97532