baron i can print you new ones when i get my upgraded printer running keep having life get in the way

I appreciate the offer, but I'm using it as an excuse to keep all hands on deck for the rostock build. Until that's done, I have TWO printers down.

Sometimes a little motivation can be a good thing!

carl_m1968 wrote:

I actually have a large hole cut in the back door with a 120mm fan mounted to it blowing directly on the board. I had to do this to get around the bed MOSFET dropping out which is known problem with RAMPS.

I am about ready to throw in the towel and sell the whole thing. it is getting on my nerves as now I can't even print the parts I need to rebuild my Delta.

Then maybe you have a problem with wiring. I had them both .

Looks like it may have been a driver and still could be the motor. It might be damaging the driver over time. I put a new driver in and printed a 2.5 hour print with no issue. Now I am going to start on an 8 hour Delta motor mount and see what happens.

I have a new complete RAMPS on the way with DRV88 drivers this time and a new motor.

I actually have a large hole cut in the back door with a 120mm fan mounted to it blowing directly on the board. I had to do this to get around the bed MOSFET dropping out which is known problem with RAMPS.

I am about ready to throw in the towel and sell the whole thing. it is getting on my nerves as now I can't even print the parts I need to rebuild my Delta.

Then maybe you have a problem with wiring. I had them both .

it is getting on my nerves as now I can't even print the parts I need to rebuild my Delta.

I know the feeling, my bf's dog chewed up my lawsy carriages mid upgrade and I need to get my delta built so I can reprint them.

Once I have it up and running, I can do a rostock vs SD3 bridge test. It'll be fun!

carl_m1968 wrote:

My extruder now starts clicking after about 10 minutes into a print. Have tried multpile filaments and same thing temps stay stable so I am not sure what it is..

try printing with mainboard outside of the printer and if you can with a fan over it.

I actually have a large hole cut in the back door with a 120mm fan mounted to it blowing directly on the board. I had to do this to get around the bed MOSFET dropping out which is known problem with RAMPS.

I am about ready to throw in the towel and sell the whole thing. it is getting on my nerves as now I can't even print the parts I need to rebuild my Delta.

My extruder now starts clicking after about 10 minutes into a print. Have tried multpile filaments and same thing temps stay stable so I am not sure what it is..

try printing with mainboard outside of the printer and if you can with a fan over it.

no one wants to play?

Still having issues. My extruder now starts clicking after about 10 minutes into a print. Have tried multpile filaments and same thing temps stay stable so I am not sure what it is..

Has anyone ever done an curved bridge

You would need support at a mid point so point to point it technically would really not be that curved.