<![CDATA[SoliForum - 3D Printing Community — Printing bed doesn't stop when going up and grinds into belt/nozzle]]> https://www.soliforum.com/topic/11246/printing-bed-doesnt-stop-when-going-up-and-grinds-into-beltnozzle/ Fri, 22 May 2015 16:10:57 +0000 PunBB <![CDATA[Re: Printing bed doesn't stop when going up and grinds into belt/nozzle]]> https://www.soliforum.com/post/96696/#p96696 Yes, please, any pictures you have would help a lot.  Also, do you know how to get the bed to lower when I turn it on?  It just grinds away.  I tried to lower it by hand but it's pretty jammed up there.  Thanks for the help!

]]> Fri, 22 May 2015 16:10:57 +0000 https://www.soliforum.com/post/96696/#p96696 <![CDATA[Re: Printing bed doesn't stop when going up and grinds into belt/nozzle]]> https://www.soliforum.com/post/96693/#p96693 Hmm, check the end-stop for the Z axis, check that nothing is covering it, and make sure that little piece that sticks out from the top of the whole Z mount it actually in line with the end-stop sensor.
If you don't know what I'm talking about, just ask and I'll upload some pictures.

Cheers big_smile

]]> Fri, 22 May 2015 15:47:43 +0000 https://www.soliforum.com/post/96693/#p96693 <![CDATA[Printing bed doesn't stop when going up and grinds into belt/nozzle]]> https://www.soliforum.com/post/96684/#p96684 My AiO printer is at 300 hours and has been printing well the entire time.  Recently, when starting a new print, the bed started to go up, but never stopped at the top and just smashed into the belt and nozzle.  It eventually gives a 0030 error.  I've tried turning the printer off and on, but it immediately starts doing the same thing with a horrible grinding noise, and I can't get the bed to lower.  Has anyone experienced this or know how to stop it?

Thanks,

Dan

]]> Fri, 22 May 2015 14:15:16 +0000 https://www.soliforum.com/post/96684/#p96684