SoliForum - 3D Printing Community — tip won't heat.

Re: tip won't heat.

null@example.com (carl_m1968) — Wed, 20 May 2015 17:53:13 +0000

kev0175 wrote:

Are you using the stock firmware because max temp is 230

True, if stock you would need to set at 225 max or an overshoot could shut it down.

When I mentioned to OP to raise their temp due to seperation I was not aware they where on stock and just using a resetter. I thought since they could change temps they had flashed.

Re: tip won't heat.

null@example.com (kev0175) — Wed, 20 May 2015 17:06:13 +0000

Are you using the stock firmware because max temp is 230

Re: tip won't heat.

null@example.com (carl_m1968) — Wed, 20 May 2015 17:05:05 +0000

zoeconner wrote:

Ive been using this resetter. Never had any problems until now. When I make a print the bed heats fine but the tip won't. I set my bed to 95 and my tip to 235 but the tip stays at room temp. OK now if I go to utilities and do a insert or remove cartridge it works fine. Any help on what to do?
http://www.ebay.com/itm/XYZprinting-da- … 1e97ba6028

The Da Vinci in stock form can't heat to 235, that is it's preset high limit. The machine thinks it is going over limit so it is shutting down the heating circuit for safety. Try setting it to 230 and it will probably work.

tip won't heat.

null@example.com (zoeconner) — Wed, 20 May 2015 16:45:48 +0000

Ive been using this resetter. Never had any problems until now. When I make a print the bed heats fine but the tip won't. I set my bed to 95 and my tip to 235 but the tip stays at room temp. OK now if I go to utilities and do a insert or remove cartridge it works fine. Any help on what to do?

http://www.ebay.com/itm/XYZprinting-da- … 1e97ba6028