<![CDATA[SoliForum - 3D Printing Community — What should I do?]]> https://www.soliforum.com/topic/11058/what-should-i-do/ Sat, 09 May 2015 02:14:59 +0000 PunBB <![CDATA[Re: What should I do?]]> https://www.soliforum.com/post/95263/#p95263 Probably shouldn't buy a Printrboard. I recommend the sanguinololu, ramps 1.4 and rumba.

The printrboard has integrated stepper drivers too. Wouldn't it be nice if this issue cost you $10 and not $100 in the future?

]]> Sat, 09 May 2015 02:14:59 +0000 https://www.soliforum.com/post/95263/#p95263 <![CDATA[What should I do?]]> https://www.soliforum.com/post/95262/#p95262 My Solidoodle Press's Z axis went out, and I found out it was the board. I hooked it up to the same type of stepper motor that I had laying around and it didn't work. I plugged it into the Y axis and it worked. So the board's Z axis pins aren't working. I bought this printer from eBay, so I don't think that Solidoodle Support won't send me a new motherboard. I was thinking just to buy a Printrboard rev F. What do you think I should do? Either talk to Support or buy a Printrboard? Thanks guys! smile

]]> Sat, 09 May 2015 02:00:30 +0000 https://www.soliforum.com/post/95262/#p95262