<![CDATA[SoliForum - 3D Printing Community — Can XYZ understand G2,G3 or is it only G1?]]> https://www.soliforum.com/topic/10894/can-xyz-understand-g2g3-or-is-it-only-g1/ Fri, 24 Apr 2015 06:40:58 +0000 PunBB <![CDATA[Re: Can XYZ understand G2,G3 or is it only G1?]]> https://www.soliforum.com/post/93968/#p93968 If your circles are bad then your bearing mounts are cracked or there is side to side play between the white pullies and retaining washers. May need to shim them.

]]> Fri, 24 Apr 2015 06:40:58 +0000 https://www.soliforum.com/post/93968/#p93968 <![CDATA[Re: Can XYZ understand G2,G3 or is it only G1?]]> https://www.soliforum.com/post/93964/#p93964 im currently on
XYZ Da Vinci 1.0A
Repetier .92MOD


do you know if there is another version that i can change it to so that i can understand?
Cause these circle is looking pretty bad.

]]> Fri, 24 Apr 2015 05:50:52 +0000 https://www.soliforum.com/post/93964/#p93964 <![CDATA[Re: Can XYZ understand G2,G3 or is it only G1?]]> https://www.soliforum.com/post/93962/#p93962 There is also G0 but the firmware that the XYZ uses only knows G1 commands. It is not a slicer limitation. But how the firmware interprets it and this firmware cannot interpret fast moves.

]]> Fri, 24 Apr 2015 05:48:21 +0000 https://www.soliforum.com/post/93962/#p93962 <![CDATA[Can XYZ understand G2,G3 or is it only G1?]]> https://www.soliforum.com/post/93961/#p93961 Hello all, I'm currently taking a CAD/CAM design class.
After looking at my GCode from Slic3r i realized that there is no G2 or G3?
So my question is can XYZ understand G2/G3 or is it that slic3r only give out G1?

]]> Fri, 24 Apr 2015 05:38:03 +0000 https://www.soliforum.com/post/93961/#p93961