SoliForum - 3D Printing Community — Capabilities of the DaVinci 1.0

Re: Capabilities of the DaVinci 1.0

null@example.com (PseudoShooter) — Mon, 13 Apr 2015 18:22:36 +0000

Thank you. I have some BuMat (clear), Inland (black and grey) and Toner Plastics (silver).

All three brands printed just fine, I found the BuMat a little brittle though.

null@example.com (Junbug) — Mon, 13 Apr 2015 18:16:57 +0000

That is super impressive and extremely colorful! What spools did you use besides xyz filament?

null@example.com (PseudoShooter) — Sat, 11 Apr 2015 19:33:37 +0000

.2 layer height with 2 shells and 25% infill. Sliced with Simplfy3d.

null@example.com (L.woinson95) — Sat, 11 Apr 2015 19:16:26 +0000

What res did you print in?

null@example.com (PseudoShooter) — Sat, 11 Apr 2015 18:50:13 +0000

I used an acetone vapor bath (cold process).

Stock extruder with my optical sensor blocked. No additional cooling.

Other than a few tweaks, my machine is stock. I use a cartridge resetter now so I can run spools.

null@example.com (oscahie) — Sat, 11 Apr 2015 18:31:48 +0000

The pieces are smoothed down with ABS, aren't they? Also, did you use the stock extruder? any additional cooling?

null@example.com (PseudoShooter) — Sat, 11 Apr 2015 12:16:22 +0000

It is. I haven't run PLA because of all the issues I keep reading that other people experience.

null@example.com (scobo) — Sat, 11 Apr 2015 05:34:20 +0000

Very nice !
Is it all in ABS ?

null@example.com (PseudoShooter) — Sat, 11 Apr 2015 04:36:13 +0000

Thank you!

null@example.com (madmike8) — Sat, 11 Apr 2015 02:53:42 +0000

Looks Good!

null@example.com (PseudoShooter) — Fri, 10 Apr 2015 23:49:27 +0000

Just finished this chess set, board and all. Took a while but it's representative of what the DaVinci can do.