<![CDATA[SoliForum - 3D Printing Community — rippling in prints on SD2 after upgrading the extruder]]> https://www.soliforum.com/topic/10596/rippling-in-prints-on-sd2-after-upgrading-the-extruder/ Sun, 29 Mar 2015 22:29:12 +0000 PunBB <![CDATA[Re: rippling in prints on SD2 after upgrading the extruder]]> https://www.soliforum.com/post/91268/#p91268 That is Moire and you can reduce it by adjusting the VREF for the extruder.

]]> Sun, 29 Mar 2015 22:29:12 +0000 https://www.soliforum.com/post/91268/#p91268 <![CDATA[rippling in prints on SD2 after upgrading the extruder]]> https://www.soliforum.com/post/91258/#p91258 Greetings,

So I have had my SD2 since they were first released..  I had it sitting in a box for about a year and recently started using it again.  I was very happy with the results, I had it dialed in pretty well.  Within a month the extruder broke so I decided to upgrade to the e3D-v6 and upgrade the power supply.  So I did the upgrade and I am up and printing again but....

I am seeing an odd rippling in my prints...  Can anyone identify the cause?  All slic3r settings are the same except the temp which I increased from 190 to 230.

The first image is the original extruder before I upgraded.  The second image is with my new E3d v6.

http://soliforum.com/i/?TUG4ENq.jpg

http://soliforum.com/i/?zudG5lh.jpg


Any help or ideas would be appreciated.

]]> Sun, 29 Mar 2015 21:53:19 +0000 https://www.soliforum.com/post/91258/#p91258