<![CDATA[SoliForum - 3D Printing Community — CTC Dual extruder, left extruder issues.]]> https://www.soliforum.com/topic/10578/ctc-dual-extruder-left-extruder-issues/ Wed, 10 Jun 2015 15:30:35 +0000 PunBB <![CDATA[Re: CTC Dual extruder, left extruder issues.]]> https://www.soliforum.com/post/98537/#p98537 also see if it knows the 35mm gap between nozzles when selecting right/left head

]]> Wed, 10 Jun 2015 15:30:35 +0000 https://www.soliforum.com/post/98537/#p98537 <![CDATA[Re: CTC Dual extruder, left extruder issues.]]> https://www.soliforum.com/post/97712/#p97712 Did you set the size of printer in software correctly?

]]> Tue, 02 Jun 2015 06:52:30 +0000 https://www.soliforum.com/post/97712/#p97712 <![CDATA[Re: CTC Dual extruder, left extruder issues.]]> https://www.soliforum.com/post/95437/#p95437 I think Goshdarnit might be on to something.

Your left extruder can go further to the left than your right extruder. Your right extruder can go further to the right than your left extruder. The center of the bed, is not really the center of each of their printing limits.

You can optimize the print space if your right nozzle does the work at the outside edges on the right, and your left does the printing at the outside left edges, otherwise, you lose print bed size, in a way. No matter which nozzle you print with, it can't go to both edges.

]]> Mon, 11 May 2015 05:49:02 +0000 https://www.soliforum.com/post/95437/#p95437 <![CDATA[Re: CTC Dual extruder, left extruder issues.]]> https://www.soliforum.com/post/92133/#p92133 Sounds like it's trying to travel beyond the edge of the bed. Is it still using the coordinates for the other extruder, so trying to get that one to the edge, which would mean pushing the left extruder past the edge? Just a thought. I've never used dual extruders, but that sounds feasible.

]]> Mon, 06 Apr 2015 06:05:37 +0000 https://www.soliforum.com/post/92133/#p92133 <![CDATA[Re: CTC Dual extruder, left extruder issues.]]> https://www.soliforum.com/post/92055/#p92055 Any input?

]]> Sun, 05 Apr 2015 02:17:48 +0000 https://www.soliforum.com/post/92055/#p92055 <![CDATA[CTC Dual extruder, left extruder issues.]]> https://www.soliforum.com/post/91128/#p91128 Hello,

I have the CTC Dual extruder printer and i have been printing perfectly with the right extruder
I began to print with the left extruder so i would not have to change filaments and so on, but when it begins the extrusion making the filament anchor from right to left it reaches the end of the bed and stop and it sounds like its stuck, then after about 2 second it goes and begins to print normally. Why would this happen only with my left extruder?

Thanks

]]> Fri, 27 Mar 2015 23:41:46 +0000 https://www.soliforum.com/post/91128/#p91128