SoliForum - 3D Printing Community — SoliPrint crashes during Z-offset Calibration

Re: SoliPrint crashes during Z-offset Calibration

null@example.com (Mischa) — Wed, 27 Jan 2016 11:15:48 +0000

Did you guys find a solution to this issue? Mine is crashing at the end of z axis calibration on soliprint 1.3. Tried two different computers, one with W7 and one with W10, both the same problem. I'm going to try an older version of Soliprint tomorrow.

Re: SoliPrint crashes during Z-offset Calibration

null@example.com (Robny) — Sat, 21 Mar 2015 17:12:38 +0000

timmij wrote:

Hi Guys,
Plugged in my Press today and been going through all the usual issues, but this one has me stumped.
Whenever I try to run the Z-Offset Calibration from SoliPrint the Press will go through the full calibration print, but just as it finishes I get a popup on my PC telling me "SoliPrint 3D Printing Software has stopped working" with the only option to close program.
I've tried it about 10 times on SoliPrint 1.1.3 (restarted SoliPrint, Press and and PC multiple times), re-installed SoliPrint, uninstalled and tried SoliPrint 1.1.2, all with no luck.
Running Windows 8.1 Pro, SoliPrint 1.1.3/1.1.2

I also have the same problem, I had a running fine for quite a while and for what ever reason it has now started crashing after the offset has run before you can enter the value. Tried on both Mac and Win and both were working fine previously.

Re: SoliPrint crashes during Z-offset Calibration

null@example.com (Goshdarnit) — Sat, 21 Mar 2015 15:56:53 +0000

I think it would work in 1.1.1, but not sure. I know people have had issues with later versions.

Re: SoliPrint crashes during Z-offset Calibration

null@example.com (trayracing) — Sat, 21 Mar 2015 13:08:18 +0000

Soliprint is not yet awesome.

In the meantime, you can calibrate manually. I think the technique has been discussed in other posts.

SoliPrint crashes during Z-offset Calibration

null@example.com (timmij) — Sat, 21 Mar 2015 08:34:54 +0000

Hi Guys,
Plugged in my Press today and been going through all the usual issues, but this one has me stumped.

Whenever I try to run the Z-Offset Calibration from SoliPrint the Press will go through the full calibration print, but just as it finishes I get a popup on my PC telling me "SoliPrint 3D Printing Software has stopped working" with the only option to close program.

I've tried it about 10 times on SoliPrint 1.1.3 (restarted SoliPrint, Press and and PC multiple times), re-installed SoliPrint, uninstalled and tried SoliPrint 1.1.2, all with no luck.

Running Windows 8.1 Pro, SoliPrint 1.1.3/1.1.2